Update Notes
	- Moxy Sensor Firmware version 0.8 to 1.0
	- Moxy PC App version 0.8 to 0.9


Be sure to download the data from the sensor and clear the data prior to doing either update.

It is important that both the Moxy Sensor Firmware and the Moxy PC App be updated.  Either one can be done first.

After the updates are complete, go into the Moxy PC App and connect to the Sensor and clear the data on the sensor again even if no new data is stored.  If you have more than 1 sensor, clear the data on all sensors prior to using them again after the update.



Here is a summary of the functionality changes with these updates:

	- We’ve added a battery charge indicator on the Moxy Sensor itself.  If you do a short click on the power button when the Sensor is turned on or off, the green LED will blink 4, 3, 2, 1, or 0 times to indicate fully charged to nearly dead.
	- When you do the short click, the yellow light will blink if the Sensor is turned on, and it won’t blink if the Sensor is off.  This is useful if you’ve already taped the Sensor down and you don’t remember if it’s on or off.
	- The Sensor time will auto sync with display devices when it pairs. This is for use with the ConnectIQ system since it doesn’t yet store the Muscle Oxygen data in the FIT file on the watch.  This auto-syncing feature will make it easier to bring the data together when it’s downloaded.
	- The Moxy PC App will make a separate FIT file for every data collection session.  A session is defined as the time from when the Sensor is turned on until it’s turned off. So if you do 3 workouts on 3 days, you will get 3 separate FIT files when you download the data rather than just 1 big one.
	- We’ve changed the smoothing of the THb values so it’s always the same as the SmO2 smoothing.  It the past, the THb had no smoothing and the SmO2 smoothing was determined by the update rate selection. This should help make the THb graphs easier to read.